D-Link DGS-1510 Series

To Next Page

To Previous Page

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide

236

are Any, Host, and IPv6. When the Any option is selected, any source

traffic will be evaluated according to the conditions of this rule. When

the Host option is selected, enter the source host’s IPv6 address here.

When the IPv6 option is selected, the Prefix Length option will also be

available. Enter the source IPv6 address and prefix length value in the

spaces provided.

Destination

Select and enter the destination information here. Options to choose

from are Any, Host, and IPv6. When the Any option is selected, any

destination traffic will be evaluated according to the conditions of this

rule. When the Host option is selected, enter the destination host’s

IPv6 address here. When the IPv6 option is selected, the Prefix

Length option will also be available. Enter the destination IPv6

address and prefix length value in the spaces provided.

DSCP

Select or enter the DSCP value used here. This value must be

between 0 and 63.

Flow Label

Enter the flow label value here. This value must be between 0 and

1048575.

Time Range

Enter the name of the time range to associate with this ACL rule.

After selecting the ESP option as the Protocol Type, the following page and parameters will be available,

as shown below:

Figure 8-71 Extended IPv6 ACL (Add Rule) ESP window

The dynamic fields that can be configured are described below:

Parameter Description

Fragments Select the Fragments option to include packet fragment filtering.

Source