DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
267
Source IP Address
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host’s IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Destination IP Address
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Source MAC Address
Select and enter the source information here. Options to choose from
are Any, Host, and MAC. When the Any option is selected, any
source traffic will be evaluated according to the conditions of this rule.
When the Host option is selected, enter the source host’s MAC
address here. When the MAC option is selected, the Wildcard option
will also be available. Enter the source MAC address and wildcard
value in the spaces provided.
Destination MAC Address
Select and enter the destination information here. Options to choose
from are Any, Host, and MAC. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s
MAC address here. When the MAC option is selected, the Wildcard
option will also be available. Enter the destination MAC address and
wildcard value in the spaces provided.
IP Precedence
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
ToS
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
DSCP
Select or enter the DSCP value used here. This value must be
between 0 and 63.
VID
Enter the VLAN ID that will be associated with this ACL rule here. This
value must be between 1 and 4094.
CoS
Select the Class of Service (CoS) value here. Options to choose from
are from 0 to 7.
Time Range
Enter the name of the time range to associate with this ACL rule.
To Next Page
Loading...
