EasyManua.ls Logo

D-Link DGS-1510 Series - Page 276

D-Link DGS-1510 Series
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
268
After selecting the None option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-100 Extended Expert ACL (Add Rule) None window
The dynamic fields that can be configured are described below:
Parameter Description
Fragments Select the Fragments option to include packet fragment filtering.
Source IP Address
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host’s IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Destination IP Address
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Source MAC Address
Select and enter the source information here. Options to choose from
are Any, Host, and MAC. When the Any option is selected, any
source traffic will be evaluated according to the conditions of this rule.
When the Host option is selected, enter the source host’s MAC
address here. When the MAC option is selected, the Wildcard option
will also be available. Enter the source MAC address and wildcard
value in the spaces provided.
Destination MAC Address
Select and enter the destination information here. Options to choose

Table of Contents

Other manuals for D-Link DGS-1510 Series

Related product manuals