Dell Force10 MXL Blade - Page 110

108 | Bare Metal Provisioning (BMP)
www.dell.com | support.dell.com
• If there is a mismatch, the system upgrades to the downloaded version and reloads.
*********VALID IMAGE***********
DOWNLOADED RELEASE HEADER :
Release Image Major Version : 8
Release Image Minor Version : 3
Release Image Main Version : 8
Release Image Patch Version : 33
FLASH RELEASE HEADER B :
Release Image Major Version : 8
Release Image Minor Version : 3
Release Image Main Version : 8
Release Image Patch Version : 28
00:04:05: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DOWNLOAD: The FTOS image download is
successful.
Erasing MXL 10/40GbE Switch IO Module Primary Image, please wait
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
..........................................................................................
...............................00:09:50: %STKUNsyncing disks... IT0-M:CP %CHMGR-1
5-RELOAD: User done
request to reload the chassis
rebooting
• If there is no version mismatch, the system downloads the configuration file.
00:03:27: %STKUNIT0-M:CP %JUMPSTART-5-CFG_APPLY: The downloaded config from dhcp
server is being applied
00:03:27: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE: DHCP RELEASE sent on Fo 0/56.
00:03:27: %STKUNIT0-M:CP %SYS-5-CONFIG_LOAD: Loading configuration file
c If the configuration file is downloaded from the server, any saved start-up configuration file on the
flash is ignored. If no configuration file is downloaded from the server, the start-up configuration
file on the flash is loaded as in normal reload.
6. When the FTOS image and the configuration file has been downloaded, the IP address is released.
7. When the boot image has been downloaded, the DHCP RELEASE is sent
00:04:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE: DHCP RELEASE sent on Fo 0/56.
00:04:06: %STKUNIT0-M:CP %IFMGR-5-ASTATE_DN: Changed interface Admin state to down: Fo 0/56
The system is now up and running, and it can be managed as usual.