1302 BigIron RX Series Configuration Guide
53-1002253-01
Syslog messages
A
Warning list <acl-num> denied <ip-proto>
<src-ip-addr> (<src-tcp/udp-port>)
(Ethernet <portnum> <mac-addr>) ->
<dst-ip-addr> (<dst-tcp/udp-port>),
1 events
Indicates that an Access Control List (ACL)
denied (dropped) packets.
The <acl-num> indicates the ACL number.
Numbers 1 – 99 indicate standard ACLs.
Numbers 100 – 199 indicate extended ACLs.
The <ip-proto> indicates the IP protocol of the
denied packets.
The <src-ip-addr> is the source IP address of
the denied packets.
The <src-tcp/udp-port> is the source TCP or
UDP port, if applicable, of the denied packets.
The <portnum> indicates the port number on
which the packet was denied.
The <mac-addr> indicates the source MAC
address of the denied packets.
The <dst-ip-addr> indicates the destination IP
address of the denied packets.
The <dst-tcp/udp-port> indicates the
destination TCP or UDP port number, if
applicable, of the denied packets.
Warning rip filter list <list-num> <direction> V1 | V2
denied <ip-addr>, <num> packets
Indicates that a RIP route filter denied
(dropped) packets.
The <list-num> is the ID of the filter list.
The <direction> indicates whether the filter
was applied to incoming packets or outgoing
packets. The value can be one of the
following:
• in
• out
The V1 or V2 value specifies the RIP version
(RIPv1 or RIPv2).
The <ip-addr> indicates the network number
in the denied updates.
The <num> indicates how many packets
matching the values above were dropped
during the five-minute interval represented by
the log entry.
Warning No of prefixes received from BGP peer
<ip-addr> exceeds warning limit <num>
The device has received more than the
allowed percentage of prefixes from the
neighbor.
The <ip-addr> is the IP address of the
neighbor.
The <num> is the number of prefixes that
matches the percentage you specified. For
example, if you specified a threshold of 100
prefixes and 75 percent as the warning
threshold, this message is generated if the
device receives a 76th prefix from the
neighbor.
Warning DOT1X security violation at port <portnum>,
malicious mac address detected:
<mac-address>
A security violation was encountered at the
specified port number.
TABLE 228 Brocade Syslog messages (Continued)
Message level Message Explanation
To Next Page
Loading...
