BigIron RX Series Configuration Guide 1317
53-1002253-01
Syslog messages
A
Informational vlan <vlan-id> Bridge is RootBridge
<mac-address> (MgmtPriChg)
802.1W changed the current bridge to be the
root bridge of the given topology due to
administrative change in bridge priority.
Informational vlan <vlan-id> Bridge is RootBridge
<mac-address> (MsgAgeExpiry)
The message age expired on the Root port so
802.1W changed the current bridge to be the
root bridge of the topology.
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change: authorized
The status of the interface’s controlled port
has changed from unauthorized to
authorized.
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change:
unauthorized
The status of the interface’s controlled port
has changed from authorized to
unauthorized.
Informational DOT1X: Port <portnum> currently used
vlan-id changes to <vlan-id> due to
dot1x-RADIUS vlan assignment
A user has completed 802.1x authentication.
The profile received from the RADIUS server
specifies a VLAN ID for the user. The port to
which the user is connected has been moved
to the VLAN indicated by <vlan-id>.
Informational DOT1X: Port <portnum> currently used
vlan-id is set back to port default vlan-id
<vlan-id>
The user connected to <portnum> has
disconnected, causing the port to be moved
back into its default VLAN, <vlan-id>.
Informational DOT1X Port <portnum> is unauthorized
because system resource is not enough or
the invalid information to set the dynamic
assigned IP ACLs or MAC address filters
802.1x authentication could not take place
on the port. This happened because strict
security mode was enabled and one of the
following occurred:
• Insufficient system resources were
available on the device to apply an IP
ACL or MAC address filter to the port
• Invalid information was received from
the RADIUS server (for example, the
Filter-ID attribute did not refer to an
existing IP ACL or MAC address filter)
Informational Port <portnum>, srcip-security
max-ipaddr-per-int reached.Last IP=<ipaddr>
The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Informational telnet | SSH | web access [by <username>]
from src IP <source ip address>, src MAC
<source MAC address> rejected, <n>
attempts
There were failed web, SSH, or Telnet login
access attempts from the specified source IP
and MAC address.
• [by <user> <username>] does not
appear if telnet or SSH clients are
specified.
• <n> is the number of times this SNMP
trap occurred in the last five minutes, or
other configured number of minutes.
Informational user <username> added | deleted |
modified from console | telnet | ssh | web |
snmp
A user created, modified, or deleted a local
user account through the Web, SNMP,
console, SSH, or Telnet session.
Informational vlan <vlan id> added | deleted | modified
from console | telnet | ssh | web | snmp
session
A user created, modified, or deleted a VLAN
through the Web, SNMP, console, SSH, or
Telnet session.
TABLE 228 Brocade Syslog messages (Continued)
Message level Message Explanation
To Next Page
Loading...
