Dell PowerConnect B-RX - Page 1394

1318 BigIron RX Series Configuration Guide
53-1002253-01
Syslog messages
A
Informational ACL <acl id> added | deleted | modified from
console | telnet | ssh | web | snmp session
A user created, modified, deleted, or applied
an ACL through the Web, SNMP, console,
SSH, or Telnet session.
Informational SNMP read-only community | read-write
community | contact | location | user |
group | view | engineld | trap [host] [<value
-str>] deleted | added | modified from
console | telnet | ssh | web | snmp session
A user made SNMP configuration changes
through the Web, SNMP, console, SSH, or
Telnet session.
[<value-str>] does not appear in the message
if SNMP community or engineld is specified.
Informational Syslog server <IP-address> deleted | added |
modified from console | telnet | ssh | web |
snmp
OR
Syslog operation enabled | disabled from
console | telnet | ssh | web | snmp
A user made Syslog configuration changes to
the specified Syslog server address, or
enabled or disabled a Syslog operation
through the Web, SNMP, console, SSH, or
Telnet session.
Informational SSH | telnet server enabled | disabled from
console | telnet | ssh | web | snmp session
[by user <username>]
A user enabled or disabled an SSH or Telnet
session, or changed the SSH enable/disable
configuration through the Web, SNMP,
console, SSH, or Telnet session.
Informational Enable super | port-config | read-only
password deleted | added | modified from
console | telnet | ssh | web | snmp
OR
Line password deleted | added | modified
from console | telnet | ssh | web | snmp
A user created, re-configured, or deleted an
Enable or Line password through the Web,
SNMP, console, SSH, or Telnet session.
Informational Port <portnum>, srcip-security
max-ipaddr-per-int reached.Last IP=<ipaddr>
The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Debug BGP4: Not enough memory available to run
BGP4
The device could not start the BGP4 routing
protocol because there is not enough
memory available.
Debug DOT1X: Not enough memory There is not enough system memory for
802.1x authentication to take place. Contact
Brocade Technical Support.
TABLE 229 BFD Syslog messages
Message level Message Explanation
Notification BFD: Session UP for NBR <neighbor-ID> on
<port>
The BFD session is UP with the neighbor
specified by the <neighbor-ID> on the port
specified by the <port> variable.
Notification BFD: Session DOWN for NBR
<neighbor-ID> on <port> Reason:
Neighbor Signaled Session Down
The BFD session with the neighbor
specified by the <neighbor-ID> on the port
specified by the <port> variable is Down
because the BFD neighbor has signaled the
session to be down.
Notification BFD: Session DOWN for NBR
<neighbor-ID> on <port> Reason:
Administratively Down
The BFD session with the neighbor
specified by the <neighbor-ID> on the port
specified by the <port> variable is Down for
Administrative reasons.
TABLE 228 Brocade Syslog messages (Continued)
Message level Message Explanation