BigIron RX Series Configuration Guide 1335
53-1002253-01
BGP4
E
med-missing-as-worst “Treating missing MEDs as the worst MEDs” on
page 770
multipath ebgp | ibgp | multi-as “Customizing BGP4 load sharing” on page 770
neighbor <ip-addr> |<peer-group-name> password [0 | 1]
<string>
“Encryption example” on page 777
neighbor <ip-addr> | <peer-group-name> capability orf
prefixlist [send | receive]
“Enabling cooperative filtering” on page 809
neighbor <ip-addr> | <peer-group-name>
soft-reconfiguration inbound
“Enabling soft reconfiguration” on page 817
neighbor <ip-addr> | <peer-group-name>
unsuppress-map <map-name>
“Removing route dampening from suppressed
neighbor routes” on page 775
neighbor <ip-addr>|<peer-group-name>
[advertisement-interval <num>]
[capability orf prefixlist [send | receive]]
[default-originate [route-map <map-name>]]
[description <string>]
[distribute-list in | out <num,num,...> | <acl-num> in |
out]
[ebgp-multihop [<num>]]
[filter-list in | out <num,num,...> | <acl-num> in | out |
weight]
[maximum-prefix <num> [<threshold>] [teardown]]
[next-hop-self]
[nlri multicast | unicast | multicast unicast]
[password [0 | 1] <string>]
[prefix-list <string> in | out]
[remote-as <as-number>]
[remove-private-as]
[route-map in | out <map-name>]
[route-reflector-client]
[send-community]
[soft-reconfiguration inbound]
[shutdown]
[timers keep-alive <num> hold-time <num>]
[unsuppress-map <map-name>]
[update-source <ip-addr> | ethernet <portnum> |
loopback <num> | ve
<num>]
[weight <num>]
“Configuring BGP4 neighbors” on page 771
“Configuring a peer group” on page 779
neighbor <ip-addr> distribute-list <name-or-num> in | out “Defining neighbor distribute lists” on page 800
neighbor <ip-addr> peer-group <peer-group-name> “Applying a peer group to a neighbor” on page 780
neighbor <ip-addr> route-reflector-client “Configuration procedures” on page 794
neighbor <ip-addr> shutdown “Administratively shutting down a session with a
BGP4 neighbor” on page 781
neighbor <peer-group-name> peer-group “Configuring a peer group” on page 779
network <ip-addr> <ip-mask> [route-map <map-name>] |
[weight <num>] | [backdoor]
“Specifying a list of networks to advertise” on
page 781
“Specifying a route map name when configuring
BGP4 network information” on page 782
next-hop-enable-default “Using the IP default route as a valid next hop for a
BGP4 route” on page 782
Commands See ...
To Next Page
Loading...
