1336 BigIron RX Series Configuration Guide
53-1002253-01
BGP4
E
next-hop-recursion “Enabling recursive next-hop lookups” on page 786
redistribute connected [metric <num>] [route-map
<map-name>]
“Redistributing connected routes” on page 787
redistribute connected | ospf | rip | isis | static “Using the IP default route as a valid next hop for a
BGP4 route” on page 782
redistribute isis level-1 | level-1-2 | level-2 [metric <num>]
[route-map <map-name>]
“Redistributing ISIS” on page 788
redistribute ospf [match internal | external1 | external2]
[metric <num>] [route-map <map-name>]
“Redistributing OSPF external routes” on page 787
redistribute rip [metric <num>] [route-map <map-name>] “Redistributing RIP routes” on page 787
redistribute static [metric <num>] [route-map
<map-name>]
“Redistributing static routes” on page 788
route-map <map-name> permit | deny <num> “Entering the route map Into the software” on
page 802
set
[as-path [pre
pend <as-num,as
-num,...>]] |
[automatic-tag] |
[comm-list <acl> delete] |
[community <num>:<num> | <num> | internet | local-as
| no-advertise | no-export] |
[dampening [<half-life> <reuse> <suppress>
<max-suppress-time>]]
[ip next hop <ip-addr>]
[ip next-hop peer-address] |
[local-preference <num>] |
[metric [+ | - ]<num> | none] |
[metric-type type-1 | type-2] | external
[metric-type internal] |
[next-hop <ip-addr>] |
[origin igp | incomplete] |
[tag <tag-value>] |
[weight <num>]
“Setting parameters in the routes” on page 806
set comm-list <acl> delete “Deleting a community from a BGP4 route” on
page 808
set ip next-hop peer-address “Setting the next hop of a BGP4 route”
on page 808
set metric-type internal “Setting a BP4 route’s MED to be equal to the
next-hop route IGP metric” on page 807
show ip bgp [route] <ip-addr>/<prefix> [longer-prefixes] |
<ip-addr>
“Displaying information for a specific route” on
page 843
show ip bgp attribute-entries “Displaying BGP4 route-attribute entries” on
page 847
show ip bgp config “Displaying the active BGP4 configuration” on
page 827
show ip bgp filtered-routes [<ip-addr>] |
[as-path-access-list <num>] | [detail] | [prefix-list
<string>]
“Displaying the filtered routes received from the
neighbor or peer group” on page 818
Commands See ...
To Next Page
Loading...
