Dell PowerConnect B-RX - Page 1415

BigIron RX Series Configuration Guide 1339
53-1002253-01
IP
E
interface ethernet <slot/port> I loopback <num> “Assigning an IP address to an Ethernet port” on
page 162
“Assigning an IP address to a loopback interface” on
page 163
interface ve <num> “Assigning an IP address to a virtual interface” on
page 163
ip address <ip-addr> <ip-mask> | <ip-addr>/<mask-bits>
[ospf-ignore I ospf-passive I secondary]
“Assigning an IP address to an Ethernet port” on
page 162
“Assigning an IP address to a loopback interface” on
page 163
“Assigning an IP address to a virtual interface” on
page 163
“Configuring the default gateway” on page 164
“Deleting an IP address” on page 164
ip arp-age <num> “Changing the ARP aging period” on page 190
ip bootp-gateway <ip-addr> “ip bootp-gateway <ip-addr>” on page 220
ip broadcast-zero “Enabling support for zero-based IP subnet
broadcasts” on page 195
ip default-gateway <ip-addr><ip-mask> I
<ip-addr>/<mask-bits>
“Configuring the default gateway” on page 164
ip default-network <ip-addr> “Configuring a default network route” on page 208
ip directed-broadcast “Enabling forwarding of directed broadcasts” on
page 194
ip dns domain-name <name> “Defining a DNS entry” on page 174
ip dns server-address <ip-addr> [<ip-addr>] [<ip-addr>]
[<ip-addr>]
“Defining a DNS entry” on page 174
ip dr-aggregate “Dropping traffic sent to the null0 interface in
hardware” on page 203
ip encapsulation snap | ethernet-2 “Changing the encapsulation type” on page 179
ip forward-protocol udp <udp-port-name> |
<udp-port-num>
“Enabling forwarding for a UDP application” on
page 217
ip helper-address <ip-addr> “Configuring an IP helper address” on page 219
ip hw-drop-on-def-route “Dropping traffic sent to the null0 interface in
hardware” on page 203
ip icmp echo broadcast-request “Disabling replies to broadcast ping requests” on
page 196
ip icmp redirects “Disabling ICMP redirect messages” on page 198
ip icmp unreachable [network | host | protocol |
administration | fragmentation-needed | port |
source-route-fail]
“Disabling ICMP destination unreachable messages”
on page 196
ip irdp [broadcast | multicast] [holdtime <seconds>]
[maxadvertinterval <seconds>] [minadvertinterval
<seconds>] [preference <number>]
“Enabling IRDP globally” on page 215
“Enabling IRDP on an individual port” on page 215
ip load-sharing [<number>] “Changing the maximum number of load sharing
paths” on page 212
Commands See ...