Dell PowerConnect B-RX - Page 1416

1340 BigIron RX Series Configuration Guide
53-1002253-01
IP
E
ip mtu <num> “Changing the maximum transmission unit on an
individual interface” on page 182
ip proxy-arp “Enabling proxy ARP” on page 190
ip redirect “Disabling ICMP redirect messages” on page 198
ip route <dest-ip-addr> <dest-mask> |
<dest-ip-addr>/<mask-bits> <next-hop-ip-addr> |
ethernet <slot/port> | ve <num> [<metric>] [tag <num>]
[distance <num>]
“Configuring a static IP route” on page 201
ip route <ip-addr> <ip-mask> |
<dest-ip-addr>/<mask-bits> null0 [<metric>] [tag <num>]
[distance <num>]
“Configuring a “null” route” on page 202
ip router-id <ip-addr> “Changing the router ID” on page 182
Ip show-portname “Displaying interface name in Syslog” on page 224
ip show-subnet-length “Changing the network mask display to prefix format”
on page 164
ip source-route “Disabling forwarding of IP source-routed packets” on
page 195
ip radius source-interface
ethernet <slot/port> |
loopback <num> |
ve <num>
“Specifying a single source interface for Telnet,
TACACS, TACACS+, or RADIUS packets” on page 183
ip tacacs source-interface
ethernet <slot/port> |
loopback <num> |
ve <num>
“Specifying a single source interface for Telnet,
TACACS, TACACS+, or RADIUS packets” on page 183
ip telnet source-interface ethernet<slot/port> |
loopback <num> |
ve <num>
“Specifying a single source interface for Telnet,
TACACS, TACACS+, or RADIUS packets” on page 183
ip ttl <1-255> “Changing the TTL threshold” on page 194
rate-limit-arp <num> “Rate limiting ARP packets” on page 188
router-interface ve <num> “Assigning an IP address to a virtual interface” on
page 163
show arp [ethernet <slot/port> | mac-address
<xxxx.xxxx.xxxx> [<mask>] | <ip-addr> [<ip-mask>]]
[<num>] [| begin<expression> | exclude<expression> |
include<expression>]
“Displaying the ARP cache” on page 224
show ip “Displaying global IP configuration information” on
page 221
show ip cache [<ip-addr>] [| begin<expression> |
exclude<expression> | include<expression> ]
“Displaying the forwarding cache” on page 226
show ip interface [ethernet <slot/port>] | [loopback
<num>] | [ve <num>]
“Displaying IP interface information” on page 223
show ip route <num> | [<ip-addr> [<ip-mask>] [debug |
detail | longer] ] | connected | bgp | isis | ospf | rip |
static | summary ] [| begin<expression> |
exclude<expression> | include<expression>]
“Displaying the IP route table” on page 228
Commands See ...