Dell PowerConnect B-RX - Page 1427

BigIron RX Series Configuration Guide 1351
53-1002253-01
IS-IS
E
default-metric <number> “Changing the default redistribution metric” on
page 883
disable-partial-spf-opt “Disabling partial SPF calculations” on page 879
distance <number> “Changing the administrative distance for IPv4 IS-IS”
on page 881
domain-password <string> “Configuring a domain password” on page 875
exit-address-family “Address family configuration level” on page 872
hello padding [point-to-point] “Globally disabling or re-enabling hello padding” on
page 878
“Disabling and enabling hello padding on an
interface” on page 888
hostname “Disabling or re-enabling display of hostname” on
page 876
ip router isis “Disabling and enabling IS-IS on an interface” on
page 886
ipv4 router isis “Interface level” on page 872
isis circuit-type level-1 | level-1-2 | level-2 “Changing the IS-IS level on an interface” on
page 888
isis hello-interval <num> [level-1-only | level-2-only] “Changing the hello interval” on page 888
isis hello-multiplier <num> [level-1-only | level-2-only] “Changing the hello multiplier” on page 889
isis metric <num> “Changing the metric added to advertised routes” on
page 889
isis passive “Disabling or re-enabling formation of adjacencies”
on page 886
isis password <string> “Limiting access to adjacencies with a neighbor” on
page 887
isis priority <num> [level-1-only | level-2-only] “Setting the priority for designated IS election” on
page 887
is-type level-1-only | level-1-2 | level-2-only “Changing the IS-IS Level globally” on page 876
log-adjacency-changes “Logging adjacency changes” on page 879
lsp interval <seconds> “Changing the LSP interval and retransmit interval”
on page 878
lsp-gen-interval <secs> “Changing the LSP generation interval” on page 877
lsp-refresh-interval <secs> “Changing the LSP refresh interval” on page 877
maximum-paths <number> “Changing the maximum number of load sharing
paths” on page 880
max-lsp-lifetime <secs> “Changing the maximum LSP lifetime”
on page 877
metric-style wide [level-1-only | level-2-only] “Changing the metric style” on page 880
net <area-id>.<system-id>.<sel> “Enabling IS-IS globally” on page 873
“Disabling and enabling IS-IS on an interface” on
page 886
Commands See ...