Dell PowerConnect B-RX - Page 1428

1352 BigIron RX Series Configuration Guide
53-1002253-01
IS-IS
E
redistribute bgp [level-1 | level-1-2 | level-2 | metric
<number> | metric-type external | internal | route-map
<name>]
“Redistributing BGP4+ routes into IPv4 IS-IS” on
page 885
redistribute connected [level-1 | level-1-2 | level-2 |
metric <number> | metric-type external | internal |
route-map <name>]
“Redistributing directly connected routes into IPv4
IS-IS” on page 884
redistribute isis level-1 into level-2 | level-2 into level-1
[prefix-list <name>]
“Redistributing IPv4 IS-IS routes within IPv4 IS-IS” on
page 886
redistribute ospf [level-1 | level-1-2 | level-2 | match
external1 | external2 | internal | metric <number> |
metric-type external | internal | route-map <name>]
“Redistributing OSPF routes into IPv4 IS-IS” on
page 885
redistribute rip [level-1 | level-1-2 | level-2 | metric
<number> | metric-type external | internal | route-map
<name>]
“Redistributing RIP routes into IPv4 IS-IS” on
page 885
redistribute static [level-1 | level-1-2 | level-2 | metric
<number> | metric-type external | internal | route-map
<name>]
“Redistributing static IPv4 routes into IPv4 IS-IS” on
page 884
retransmit-interval “Changing the LSP interval and retransmit interval”
on page 878
route-map <map-name> permit | deny
<sequence-number>
“Enabling advertisement of a default route” on
page 880
router isis “Global configuration level” on page 871
“Disabling and enabling IS-IS on an interface” on
page 886
set level level-1 | level-1-2 | level-2 “Enabling advertisement of a default route” on
page 880
set-overload-bit [on-startup <secs>] “Setting the overload bit” on page 874
show isis config “Displaying the IS-IS configuration in the
running-config” on page 890
show isis counts “Displaying error statistics” on page 901
show isis database [<lsp-id> | detail | l1 | l2 | level1 |
level2]
“Displaying summary information” on page 897
show isis database detail [l1 | l2 | level1 | level2] “Displaying detailed information” on page 898
show isis hostname “Displaying the name mappings” on page 890
show isis interface “Displaying interface information” on page 893
show isis neighbor
“Displaying neighbor information” on page 891
show isis routes “Displaying route information” on page 896
show isis traffic “Displaying traffic statistics” on page 900
show logging “Displaying IS-IS Syslog messages” on page 892
spf-interval <secs> “Changing the SPF timer” on page 878
summary-address <ip-addr> <ip-mask> [level-1-only |
level-1-2 | level-2-only]
“Configuring summary addresses” on page 882
Commands See ...