Dell PowerConnect B-RX - Page 324

248 BigIron RX Series Configuration Guide
53-1002253-01
Deploying a LAG
8
=== LAG "d1" (dynamic Deployed) ===
LAG Configuration:
Ports: ethe 13/2 to 13/3 ethe 32/2
Primary Port: 32/2
LACP Key: 104
Deployment: Trunk ID 3
Port Link L2 State Dupl Speed Trunk Tag Priori MAC Name
3/2 Up Forward Full 10G 3 Yes level0 0004.80a0.44d9
13/3 Up Forward Full 10G 3 Yes level0 0004.80a0.44d9
32/2 Up Forward Full 10G 3 Yes level0 0004.80a0.44d9
Port [Sys P] [Port P] [ Key ] [Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]
13/2 1 1 104 Yes L Agg Syn Col Dis No No Ope
13/3 1 1 104 Yes L Agg Syn Col Dis No No Ope
32/2 1 1 104 Yes L Agg Syn Col Dis No No Ope
=== LAG "e" (dynamic Deployed) ===
LAG Configuration:
Ports: ethe 2/1 ethe 2/3 ethe 2/5
Primary Port: 2/3
LACP Key: 105
Deployment: Trunk ID 1
Port Link L2 State Dupl Speed Trunk Tag Priori MAC Name
2/1 Up Forward Full 1G 1 Yes level0 0004.80a0.402a
2/3 Up Forward Full 1G 1 Yes level0 0004.80a0.402a
2/5 Up Forward Full 1G 1 Yes level0 0004.80a0.402a
Port [Sys P] [Port P] [ Key ] [Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]
2/1 1 1 105 Yes L Agg Syn Col Dis No No Ope
2/3 1 1 105 Yes L Agg Syn Col Dis No No Ope
2/5 1 1 105 Yes L Agg Syn Col Dis No No Ope
Syntax: show lag <lag-name> [brief] [deployed] [dynamic] [keep-alive] [static]
Table 58 describes the information displayed by the show lag command.
TABLE 58 Show LAG information
This field... Displays...
Total number of LAGS The total number of LAGs that have been configured on the switch.
Total number of Deployed LAGS The total number of LAGs on the switch that are currently deployed.
Total number of Trunks Created The total number of trunks that have been created on the LAG. The total
number of Trunks available are shown also. Since keep-alive LAGs do not
use a trunk ID, they are not listed and do not subtract for the number of
trunks available.
LACP System Priority /ID The system priority configured for the switch .
The ID is the system priority which is the base MAC address of the
switch.
LACP Long timeout
LACP Short timeout
The following information is displayed per-LAG in the show lag brief command.
LAG The name of the LAG.