BigIron RX Series Configuration Guide 249
53-1002253-01
Deploying a LAG
8
Type The configured type of the LAG: static, dynamic, or keep-alive
Deploy Status of LAG deployment:
Y – yes, LAG is deployed.
N – no, LAG is not deployed.
Trunk The trunk ID number.
Primary The primary port of the LAG.
Port List The list of ports that are configured in the LAG.
The following information is displayed per-LAG the show lag command for each LAG configured.
LAG configuration
Ports List of ports configured with the LAG.
Primary Port: The primary port configured on the LAG.
LACP Key The link aggegation key for the LAG.
Deployment The Trunk ID number.
Port The slot and port number of the interface.
Link The status of the link which can be one of the following:
• up
• down
L2 State The L2 state for the port.
Dupl The duplex state of the port, which can be one of the following:
• Full
• Half
• None
Speed The bandwidth of the interface.
Trunk The Trunk ID of the por t.
Tag Indicates whether the ports have 802.1q VLAN tagging. The value can
be Yes or No.
Priori Indicates the Quality of Service (QoS) priority of the ports. The priority
can be a value from 0 – 7.
MAC The MAC address of the port.
Name The name (if any) configured for the port.
Sys P Lists the system priority configured for the device.
Port P Lists the port’s link aggregation priority.
Key Lists the link aggregation key.
TABLE 58 Show LAG information (Continued)
This field... Displays...
To Next Page
Loading...
