l BigIron RX Series Configuration Guide
53-1002253-01
Enhancements in release 02.7.00
TABLE 6 Summary of enhancements in release 02.7.00
Enhancement Description See page
True Remote Console The new rconsole feature provides a true
connection to the MP/LP console port. While the
old session-based rconsole is a remote X-Window
which is connected to one of the windows on the
target system, the new rconsole is a remote
desktop.
N/A
Limited/Fixed Boot Code Book: Foundry BigIron RX
Configuration Guide
Chapter:
Section:
True Remote Console The new rconsole feature provides a true
connection to the MP/LP console port. While the
old session-based rconsole is a remote X-Window
which is connected to one of the windows on the
target system, the new rconsole is a remote
desktop.
N/A
Limited/Fixed Boot Code Book: Foundry BigIron RX
Configuration Guide
Chapter:
Section:
Layer 1 features
New Optics Support The SFP-compliant E1MG-TX fiber-optic module now
supports speeds of 10/100/1000.
Book: Brocade BigIron RX
Series Installation Guide
UDLD Start-up Mode In this release, after UDLD is enabled on a port,
UDLD can be configured to be kept in a newly
created suspended state until it receives its first
keep-alive message from the other end.
Book: BigIron RX Series
Configuration Guide
Chapter:“Configuring
Uni-Directional Link
Detection (UDLD)”
Multicast, Broadcast, and
Unknown Unicast Rate
Limiting per Module
This release introduces a new hardware (module)
based Multicast/Broadcast/Unknown Unicast
Rate-Limiting for both CPU based flooding and
Hardware based flooding.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring
Traffic Reduction”
Section: “NP based
multicast, broadcast, and
unknown-unicast rate
limiting”
Link Layer Discovery Protocol
(LLDP)
Beginning with release 02.7.00, Link Layer
Discovery Protocol (LLDP) is supported. This
protocol enables a station to advertise its
capabilities to, and to discover other LLDP-enabled
stations in the same 802.1AB LAN segments.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring
LLDP”
To Next Page
Loading...
