746 BigIron RX Series Configuration Guide
53-1002253-01
Configuring BGP4
26
as-path-ignore x “Disabling or re-enabling comparison of the
AS-path length” on page 760
bgp-redistribute-internal x “Redistributing IBGP routes” on page 760
client-to-client-reflection “Disabling or re-enabling client-to-client route
reflection” on page 761
cluster-id x “Configuring a route reflector” on page 761
community-filter x
compare-routerid x “Enabling or disabling comparison of the
router IDs” on page 761
confederation x “Configuring confederations” on page 762
dampening x x “Configuring route flap dampening” on
page 765
default-information-origi
nate
xx“Originating the default route” on page 765
default-local-preference x “Changing the default local preference” on
page 766
default-metric x x “Changing the default metric used for
redistribution” on page 766
distance x “Changing administrative distances” on
page 767
enforce-first-as x “Requiring the first AS to be the neighbor’s
AS” on page 768
exit-address-family x x x “Entering and exiting the address family
configuration level” on page 751
fast-external-fallover x “Enabling fast external fallover” on page 768
local-as x “Setting the local AS number” on page 769
maximum-paths x “Changing the maximum number of shared
BGP4 paths” on page 769
med-missing-as-worst x “Treating missing MEDs as the worst MEDs”
on page 770
multipath x “Customizing BGP4 load sharing” on
page 770
neighbor x x x “Configuring BGP4 neighbors” on page 771
“Configuring a BGP4 peer group” on
page 778
network x x “Specifying a list of networks to advertise” on
page 781
next-hop-enable-default x “Using the IP default route as a valid next hop
for a BGP4 route” on page 782
next-hop-recursion x “Enabling next-hop recursion” on page 783
TABLE 120 IPv4 BGP commands at different configuration levels (Continued)
Command Global
(iPv4 and
IPv6)
IPv4 address
family unicast
IPv4 address
family
multicast
See
To Next Page
Loading...
