Dell PowerConnect B-RX - Page 823

BigIron RX Series Configuration Guide 747
53-1002253-01
Configuring BGP4
26
redistribute x x “Modifying redistribution parameters” on
page 786
show x x x “Displaying BGP4 information” on page 824
table-map x x “Using a table map to set the tag value” on
page 789
timers x “Changing the keep alive time and hold time”
on page 789
update-time x x “Changing the BGP4 next-hop update timer”
on page 790
TABLE 120 IPv4 BGP commands at different configuration levels (Continued)
Command Global
(iPv4 and
IPv6)
IPv4 address
family unicast
IPv4 address
family
multicast
See
TABLE 121 IPv4 and IPv6 BGP Commands at Different Configuration Levels
Command Global
(iPv4
and
IPv6)
IPv4
Address
Family
Unicast
IPv4
Address
Family
Multicast
IPv6
Address
Family
Unicast
See
address-family x x x x “Entering and exiting the address family
configuration level” on page 751
address-filter x “Filtering specific IP addresses” on
page 751
aggregate-address x x x “Aggregating routes advertised to BGP4
neighbors” on page 759
always-compare-med x “Configuring the device to always compare
MEDs” on page 759
as-path-filter x
as-path-ignore x “Disabling or re-enabling comparison of the
AS-path length” on page 760
bgp-redistribute-intern
al
xx“Redistributing IBGP routes” on page 760
client-to-client-reflectio
n
x “Disabling or re-enabling client-to-client
route reflection” on page 761
cluster-id x “Configuring a route reflector” on page 761
community-filter x
compare-routerid x “Enabling or disabling comparison of the
router IDs” on page 761
confederation x “Configuring confederations” on page 762
dampening x x x “Configuring route flap dampening” on
page 765