748 BigIron RX Series Configuration Guide
53-1002253-01
Configuring BGP4
26
default-information-ori
ginate
xxx“Originating the default route” on page 765
default-local-preferenc
e
x “Changing the default local preference” on
page 766
default-metric x x x “Changing the default metric used for
redistribution” on page 766
distance x “Changing administrative distances” on
page 767
enforce-first-as x “Requiring the first AS to be the neighbor’s
AS” on page 768
exit-address-family x x x x “Entering and exiting the address family
configuration level” on page 751
fast-external-fallover x “Enabling fast external fallover” on page 768
local-as x “Setting the local AS number” on page 769
maximum-paths x x “Changing the maximum number of shared
BGP4 paths” on page 769
med-missing-as-worst x “Treating missing MEDs as the worst MEDs”
on page 770
multipath x x “Customizing BGP4 load sharing” on
page 770
neighbor x x x x “Configuring BGP4 neighbors” on page 771
“Configuring a BGP4 peer group” on
page 778
network x x x “Specifying a list of networks to advertise”
on page 781
next-hop-enable-defaul
t
xx“Using the IP default route as a valid next
hop for a BGP4 route” on page 782
next-hop-recursion x “Enabling next-hop recursion” on page 783
redistribute x x x “Modifying redistribution parameters” on
page 786
show x x x x “Displaying BGP4 information” on page 824
table-map x x x “Using a table map to set the tag value” on
page 789
timers x “Changing the keep alive time and hold
time” on page 789
update-time x x “Changing the BGP4 next-hop update timer”
on page 790
TABLE 121 IPv4 and IPv6 BGP Commands at Different Configuration Levels (Continued)
Command Global
(iPv4
and
IPv6)
IPv4
Address
Family
Unicast
IPv4
Address
Family
Multicast
IPv6
Address
Family
Unicast
See
To Next Page
Loading...
