BigIron RX Series Configuration Guide 907
53-1002253-01
Displaying Bidirectional Forwarding Detection information
29
BigIron RX# show bfd
BFD State: ENABLED Version: 1
Current Registered Protocols: ospf ospf6
All Sessions: Current: 2 Maximum Allowed: 100 Maximum Exceeded Count: 0
LP Sessions: Maximum Allowed on LP: 20 Maximum Exceeded Count for LPs: 0
LP Sessions LP Sessions LP Sessions LP Sessions
1 0 2 2 3 0 4 0
5 0 6 0 7 0 8 0
9 0 10 0 11 0 12 0
13 0 14 0 15 0 16 0
BFD Enabled ports count: 2
Port MinTx MinRx Mult Sessions
eth 2/1 100 100 3 2
Syntax: show bfd
This display shows the following information.
TABLE 143 Display of BFD information
This field... Displays...
BFD State Specifies if BFD is Enabled or Disabled on the router.
Version Specifies the version of the BFD protocol operating on the router.
Current Registered Protocols Specifies which protocols are registered to use BFD on the router.
Possible values are ospf, ospf6, or isis_task
All Sessions
Current: The number of BFD sessions currently operating on the router.
Maximum Allowed The maximum number of BFD sessions that are allowed on the router.
The maximum number of sessions supported on a router is 100.
Maximum Exceeded Count The number of times the request to set up a BFD session was declined
because it would have resulted in exceeding the maximum number of
BFD sessions allowed on the router.
LP Sessions
Maximum Allowed on LP The maximum number of BFD sessions that are allowed on an interface
module. The maximum number of sessions supported on an interface
module is 20.
Maximum Exceeded Count for LPs The number of times the request to set up a BFD session was declined
because it would have resulted in exceeding the maximum number of
BFD sessions allowed on an Interface module.
LP The number of the Interface module that the Current Session Count is
displayed for.
Sessions The number of BFD sessions currently operating on the specified
Interface module.
BFD Enabled ports count The number of ports on the router that have been enabled for BFD.
Port The port that BFD is enabled on.
MinTx The interval in milliseconds between which the router desires to send a
BFD message from this port to its peer.
MinRx The interval in milliseconds that this router desires to receive a BFD
message from its peer on this port.
To Next Page
Loading...
