Dell PowerConnect B-RX - Page 984

908 BigIron RX Series Configuration Guide
53-1002253-01
Displaying Bidirectional Forwarding Detection information
29
Displaying BFD application information
The following example illustrates the output from the show bfd application command.
BigIron RX# show bfd application
Registered Protocols Count: 3
Protocol Parameter
ospf 1
ospf6 0
isis_task 0
This display shows the following information.
Displaying BFD neighbor information
The following example illustrates the output from the show bfd neighbor command.
BigIron RX# show bfd neighbor
Total number of Neighbor entries: 2
NeighborAddress State Interface Holddown Interval RH
12.14.1.1 UP eth 3/1 300000 100000 1
12.2.1.1 UP eth 2/1 300000 100000 1
Syntax: show bfd neighbor [interface ethernet <slot/port> | interface pos <slot/port> | interface
ve <port-no>]
The interface ethernet option displays BFD neighbor information for the specified ethernet
interface only.
The interface ve option displays BFD neighbor information for the specified virtual interface only.
This display shows the following information.
Mult The number of times that the router will wait for the MinRx time on this
port before it determines that its peer router is non-operational.
Sessions The number of BFD sessions originating on this port.
TABLE 144 Display of BFD application information
This field... Displays...
Parameter The parameter value passed by the protocol during registration with BFD.
TABLE 145 Display of BFD information
This field... Displays...
Total number of Neighbor entries The number of neighbors that have established BFD sessions with ports on
this router.
NeighborAddress The IPv4 or IPv6 address of the remote peer.
State The current state of the BFD session.
Up - Up
Down - Down
A.DOWN – The administrative down state.
INIT – The Init state.
UNKNOWN – The current state is unknown.
TABLE 143 Display of BFD information (Continued)
This field... Displays...