BigIron RX Series Configuration Guide 909
53-1002253-01
Displaying Bidirectional Forwarding Detection information
29
To display BFD Neighbor information in the detailed format use the following command.
BigIron RX# show bfd neighbor details
Total number of Neighbor entries: 1
NeighborAddress State Interface Holddown Interval RH
12.14.1.1 UP ve 50 300000 100000 1
Registered Protocols: ospf
Local: Disc: 1, Diag: 0, Demand: 0 Poll: 0
MinTxInterval: 100000, MinRxInterval: 100000, Multiplier: 3
Remote: Disc: 22, Diag: 7, Demand: 0 Poll: 0
MinTxInterval: 100000, MinRxInterval: 100000, Multiplier: 3
Stats: RX: 72089 TX: 72101 SessionUpCount: 1 at SysUpTime: 0:1:30:54.775
Session Uptime: 0:1:30:6.375, LastSessionDownTimestamp: 0:0:0:0.0
Physical Port: eth 4/1, Vlan Id: 50
Syntax: show bfd neighbor details [IpAddress | IPv6Address]
This display shows the following information.
Interface The logical port (physical or virtual port) on which the peer is known. The
physical port can be either Ethernet or POS.
Holddown The interval after which the session will transition to the down state if no
message is received.
Interval The negotiated interval at which the local router sends BFD messages to the
remote peer.
RH Heard from remote.
TABLE 146 Display of BFD neighbor detail information
This field... Displays...
Total number of Neighbor entries Total number of BFD sessions.
NeighborAddress IPv4 or IPv6 address of the remote peer.
State The current state of the BFD session.
Up
Down
A.DOWN – The administrative down state.
INIT – The Init state.
UNKNOWN – The current state is unknown.
Interface The logical port on which the peer is known.
Holddown The interval after which the session will transition to the down state if no
message is received.
Interval The interval at which the local router sends BFD messages to the remote
peer.
RH Heard from remote.
Registered Protocols Specifies which protocols are registered to use BFD on this port.
Local
Disc Value of the “local discriminator” field in the BFD Control Message as
used by the local router in the last message sent.
TABLE 145 Display of BFD information (Continued)
This field... Displays...
To Next Page
Loading...
