Chapter 4 Parameters
4-52
30.0 (a decimal point).
00-06 Software Version
Control
mode
VF VFPG SVC FOCPG TQCPG
Factory setting: Read Only
Settings Read Only
Display #.##
00-07 Password Input Unit: 1
Control
mode
VF VFPG SVC FOCPG TQCPG
Factory setting: 00
Settings 1 to 9998 and 10000 to 65535
Display 00~02 (times of wrong password)
The function of this parameter is to input the password that is set in Pr.00-08. Input the
correct password here to enable changing parameters. You are limited to a maximum of
3 attempts. After 3 consecutive failed attempts, a blinking “PcodE” will show up to force
the user to restart the AC motor drive in order to try again to input the correct password.
When forgetting password, you can decode by setting 9999 and press button
and
repeat it again (setting 9999 and press button
again). Please note that all the
settings will be set to factory setting.
00-08 Password Set
Unit: 1
Control
mode
VF VFPG SVC FOCPG TQCPG
Factory setting: 00
Settings 1 to 9998 and 10000 to 65535
Display 00 No password set or successful input in Pr. 00-07
01 Password has been set
To set a password to protect your parameter settings.
If the display shows 00, no password is set or password has been correctly entered in
Pr.00-07. All parameters can then be changed, including Pr.00-08.
The first time you can set a password directly. After successful setting of password the
display will show 01 which means password protection is now effective. And all the
parameters will display 0 (except Pr00-07 and Pr00-08) and cannot be modified.
Be sure to record the password for later use.
To cancel the parameter lock, set the parameter to 00 after inputting correct password
To Next Page
Loading...
