Delta VFD-VE - Multi-Function Output 4 (MO2); Multi-Function Output 5 (MO3) (Need to Use with EMV-APP01); Multi-Function Output 5 6 (MO4) (Need to Use with EMV-APP01); Multi-Function Output 12 (MOA) (Need to Use with EMV-APP01)

Chapter 4 Parameters
4-83
02-14  Multi-function Output 4 (MO2)
Factory Setting: 0
02-35  Multi-function Output 5 (MO3) (need to use with EMV-APP01)
Factory Setting: 0
02-36 Multi-function Output 5 6 (MO4) (need to use with EMV-APP01)
Factory Setting: 0
02-37  Multi-function Output 5 7 (MO3MO5) (need to use with EMV-APP01)
Factory Setting: 0
02-38  Multi-function Output 8 (MO6) (need to use with EMV-APP01)
Factory Setting: 0
02-39  Multi-function Output 9 (MO7) (need to use with EMV-APP01)
Factory Setting: 0
02-40  Multi-function Output 10 (MO8) (need to use with EMV-APP01)
Factory Setting: 0
02-41  Multi-function Output 11 (MO9) (need to use with EMV-APP01)
Factory Setting: 0
02-42  Multi-function Output 12 (MOA) (need to use with EMV-APP01)
Factory Setting: 0
Settings 0-50
Summary of function settings (Take the normally open contact for example, ON: contact is closed,
OFF: contact is open)
Settings
Control Mode
VF VFPG SVC FOCPG TQCPG
0: No function
1: Operation indication
○ ○ ○ ○ ○
2: Operation speed attained
○ ○ ○ ○ ○
3: Desired frequency attained 1 (Pr.02-19)
○ ○ ○ ○ ○
4: Desired frequency attained 2 (Pr.02-21)
○ ○ ○ ○
5: Zero speed (frequency command)
○ ○ ○ ○
6: Zero speed with stop (frequency command)
○ ○ ○ ○
7: Over torque (OT1) (Pr.06-06~06-08)
○ ○ ○ ○ ○
8: Over torque (OT2) (Pr.06-09~06-11)
○ ○ ○ ○ ○
9: Drive ready
○ ○ ○ ○ ○
10: User-defined Low-voltage Detection
○ ○ ○ ○ ○
11: Malfunction indication
○ ○ ○ ○ ○
12: Mechanical brake release (Pr.02-31)
○ ○ ○ ○ ○
13: Overheat
○ ○ ○ ○ ○
14: Software brake signal indication
○ ○ ○ ○ ○
15: PID feedback error
○ ○ ○ ○ ○
16: Slip error (oSL)
○ ○ ○ ○
17: Terminal count value attained (Pr.02-16)
○ ○ ○ ○ ○
18: Preliminary count value attained (Pr.02-17)
○ ○ ○ ○ ○
19: Baseblock (B.B.) Indication
○ ○ ○ ○ ○