Delta VFD-VE - Page 54

Chapter 4 Parameters
4-3
Pr. Explanation Settings
Factory
Setting
VF VFPG SVC FOCPG TQCPG
00-11
V/f Curve Selection
0: V/f curve determined by group 01
1: 1.5 power curve
2: Square curve
0
○ ○
00-12
Constant/Variable Torque
Selection
0: Constant Torque (150%)
1: Variable Torque (120%)
0
○ ○ ○ ○
00-13
Optimal
Acceleration/Deceleration
Setting
0: Linear accel./decel. I
1: Auto accel., linear decel.
2: Linear accel., auto decel.
3: Auto accel./decel. (auto calculate the accel./decel.
time by actual load)
4: Stall prevention by auto accel./decel. (limited by 01-12
to 01-21)
0
○ ○ ○ ○
00-14
Time Unit for
Acceleration/Deceleration
and S Curve
0: Unit: 0.01 second
1: Unit: 0.1 second
0
○ ○ ○ ○
00-15 Reserved
00-16 Reserved
00-17
Carrier Frequency
1~15KHz 10
○ ○ ○ ○ ○
00-18
Auto Voltage Regulation
(AVR) Function
0: Enable AVR
1: Disable AVR
2: Disable AVR when deceleration stop
0
○ ○ ○ ○ ○
00-19
Auto Energy-saving
Operation
0: Disable
1: Enable
0
○ ○ ○ ○
00-20
Source of the Master
Frequency Command
0: Digital keypad (KPV-CE01)
1: RS-485 serial communication
2: External analog input (Pr. 03-00)
3: External UP/DOWN terminal
4: Pulse input without direction command (Pr.10-15
without direction)
5: Pulse input with direction command (Pr.10-15)
0
○ ○ ○ ○
00-21
Source of the Operation
Command
0: Digital keypad (KPV-CE01)
1: External terminals. Keypad STOP disabled.
2: RS-485 serial communication (RJ-11). Keypad STOP
disabled.
0
○ ○ ○ ○ ○
00-22
Stop Method
0: Ramp to stop
1: Coast to stop
0
○ ○ ○ ○ ○
00-23
Motor Direction Control
0: Enable forward/reverse
1: Disable reverse
2: Disable forward
0
○ ○ ○ ○ ○