Digi TransPort LR54 - Page 103

Hotspot Hotspot configuration
Digi TransPort WR Routers User Guide
103
Web
1. Enable and configure the hotspot for click-through authentication:
a. On the menu, click Network > Services > Hotspot.
b. Click Enable to enable the hotspot.
c. For LAN, select a LANfor the hotspot. See Hotspot LANconfiguration for important
information about selecting a LANfor the hotspot.
d. For Login, select the login type:
n Local Page—Uses an HTMLpage for authentication that is stored locally on
the TransPort device's filesystem, in the hotspot directory. Note that the
hotspot directory is not visible until hotspot has been enabled for the first
time.
n Remote URL—Uses an HTML page for authentication that is served by a
remote web server.
e. Local Page/Remote URL:
n If Local Page is selected for the Login type, the Local Page field is
displayed. Normally, this field should be left blank, and the TransPort device
will use the default authentication HTMLpage (for click-through
authentication, the default authentication page is terms.html). If you upload
a custom HTML file that uses a filename other than the default filename, you
should select the custom filename here. See Upload custom hotspot HTML
pages for more information about creating and uploading custom HTML files.
n If Remote URL is selected for the Login type, enter the URL in the Remote
URL field. The URL must begin with http:// or https://. The server listed
here must also be included in the Allowed Domains or Allowed Subnets.
f. For IP Address, enter the IP address for the hotspot's LAN. The default is 10.1.0.1.
This IP address also defines the subnet that will be used by the hotspot's DHCP
server. See Hotspot DHCP server for more information.
g. For Subnet Mask, enter the subnet mask for the hotspot's LAN. The default is
255.255.255.0.
h. For Auth Mode, select Click-Through.
i. Click Advanced.
Many of the advanced hotspot settings are optional or contain default values that
normally do not need to be changed.
j. For Server Port, enter the port number for the hotspot server. The default is 4990.
k. For Auth Port, enter the port number for the hotspot authentication server. The
default is 3990.
l. For Max Download and Max Upload, define the throughput limits that will be
applied to clients that connect to the hotspot. Enter the number and selected
either Kbps or Mbps. The default for both is 10 Mbps.
m. For DHCP Lease Length, enter the duration of the DHCP server lease in seconds.
The default is 600 seconds.