Digi TransPort LR54 - Cellular

Command reference cellular
Digi TransPort WR Routers User Guide
355
cellular
Configures a cellular interface.
Syntax
cellular <1 - 2> <parameter> <value>
Parameters
description
A description of the cellular interface.
Accepted value is any string up to 63 characters.
sim1-apn
The Access Point Name (APN) for the cellular interface.
Accepted value is any string up to 63 characters.
sim1-username
The username for the APN.
Accepted value is any string up to 63 characters.
sim1-password
The password for the APN.
Accepted value is any string up to 128 characters.
sim1-pin
The PIN for SIM1. The PIN is a number between 4 to 8 digits long. If no value is specified for this
parameter, no PIN is needed to activate the SIM1.
Accepted value is any string up to 64 characters.
sim1-preferred-mode
The preferred cellular mode for the cellular interface.
Accepted values can be one of auto, 4g, 3g or 4g3g. The default value is auto.
sim1-connection-attempts
The number of attempts to establish a cellular connection. After this number of attempts, the cellular
module is power cycled, and the device attempts to make a cellular connection again.
Accepted value is any integer from 10 to 500. The default value is 20.
sim1-registration-timeout
Number of seconds to wait for registration before rebooting the module.
Accepted value is any integer from 60 to 10000. The default value is 180.