Digi TransPort LR54 - Page 356

Command reference cellular
Digi TransPort WR Routers User Guide
356
sim2-apn
The Access Point Name (APN) for the cellular interface.
Accepted value is any string up to 63 characters.
sim2-username
The username for the APN.
Accepted value is any string up to 63 characters.
sim2-password
The password for the APN.
Accepted value is any string up to 128 characters.
sim2-pin
The PIN for SIM2. The PIN is a number between 4 to 8 digits long. If no value is specified for this
parameter, no PIN is needed to activate the SIM2.
Accepted value is any string up to 64 characters.
sim2-preferred-mode
The preferred cellular mode for the cellular interface.
Accepted values can be one of auto, 4g, 3g or 4g3g. The default value is auto.
sim2-connection-attempts
The number of attempts to establish a cellular connection. After this number of attempts, the cellular
module is power cycled, and the device attempts to make a cellular connection again.
Accepted value is any integer from 10 to 500. The default value is 20.
sim2-registration-timeout
Number of seconds to wait for registration before rebooting the module.
Accepted value is any integer from 60 to 10000. The default value is 180.
Examples
n
cellular 1 sim1-apn broadband
Set the SIM slot 1 APN to 'broadband.'
n
cellular 1 sim1-username my-username
Set the SIM slot 1 username to 'my-username.'
n
cellular 1 sim1-password my-password
Set the SIM slot 1 password to 'my-password.'
n
cellular 1 sim2-username my-username
Set the SIM slot 2 username to 'my-username.'