Command reference location
Digi TransPort WR Routers User Guide
393
location
Configures location settings.
Syntax
location <parameter> <value>
Parameters
interval
Set the refresh interval in seconds for reading and sending location data.
Accepted value is any integer from 1 to 3600. The default value is 10.
vehicle-id
Set the vehicle ID to include in TAIP messages.
Accepted value is any string between 4 and 4 characters. The default value is 0000.
server-port
IP UDP port to listen for location messages. If 0, this feature is disabled.
Accepted value is any integer from 0 to 65535. The default value is 0.
state
Enable or disable location information.
Accepted values can be one of off, gnss or server. The default value is gnss.
To Next Page
Loading...
