Digi TransPort LR54 - Show WAN Status and Statistics

Wide Area Networks (WANs) Show WAN status and statistics
Digi TransPort WR Routers User Guide
64
6. Optional: Configure the time, in seconds, that the primary interface needs to be up before
switching back to it as the active interface. If probing is active, no probes are permitted to be
lost during this period. Otherwise, the timer is restarted. Accepted value is any integer from 0
to 3600. The default value is 0.
digi.router> wan 1 activate-after 30
7. Optional: Configure the time, in seconds, to wait before retrying this interface after failing over
to a lower priority one. Use a large retry timeout when both interfaces are cellular interfaces.
Accepted value is any integer from 10 to 3600. The default value is 180.
digi.router> wan 1 retry-after 1200
8. Save the configuration.
digi.router> save config
Show WAN status and statistics
You can view status and statistics for all WANs from either Web UI or the command line.
Web
1. On the menu, click Network > Networks > WANs. The WANs page appears.
2. Select a WAN.
The WAN page shows configuration parameters, as well as status and statistics for the
interface assigned to the WAN.
Command line
Show WAN summary statistics
To show the status and statistics for a WAN, use the show wan command. For example:
digi.router> show wan
# WAN Interface Status IP Address
-----------------------------------
1 eth1 Up 192.168.0.25
2 cellular1 Up 172.20.1.7
digi.router>
Show status and statistics for the WAN physical interface
To view status and statistics for the physical interface for the WAN,enter the show command for that
physical interface; for example, show eth or show cellular.
Show detailed WAN status
To show detailed status for a WAN, enter the show wan command, specifying the WANinstance
number. For example, for a WAN on which IPv6 is enabled:
digi.router> show wan 1
WAN 1 Status and Statistics