Digi TransPort LR54 - Local Users; User Access Levels

Security Local users
Digi TransPort WR Routers User Guide
74
Local users
To access a TransPort device (via the command-line interface or web interface), users must log in as a
configured user of the device. This topic details the TransPortuser model, as well as how to create,
modify, and delete users.
Maximum number of users
TransPort allows you to configure up to 10 users for a device, user 1 through user 10. Each user has a
unique username, password, and access level.
Default user
As manufactured, each TransPort device comes with a default user 1 configured as follows:
Username: admin
Password: The default password is displayed on the label on the bottom of the device.
For example:
Access: super
Note The default password is a unique password for the device, and is the most critical
security feature for the device. Anytime you reset the device to factory defaults, you
should immediately change the password from the default to a custom password.
Before deploying or mounting the TransPort device, take a photo of or otherwise record
the default password, so you have the information available when you need it even if
you cannot physically access the label on the bottom of the device.
You can change the default user 1 configuration to match your site requirements.
User access levels
TransPort devices support three access levels: super, read-write, and read-only. These access levels
determine the level of control users have over device features and settings.