Digi TransPort LR54 - Show VRRP Status and Statistics

Routing Virtual Router Redundancy Protocol (VRRP)
Digi TransPort WR Routers User Guide
189
Web
Edit the settings for the LAN and click Apply. This updates the DHCP server settings to the correct
default of 0.0.0.0. If you are accessing the router via this LAN interface, you need to reconnect to it
using the new IP address. If desired, you may then change the IP address setting back to the original
value.
Command line
Run the following commands, replacing x with the index of the LAN interface used for VRRP.
dhcp-server x gateway 0.0.0.0
dhcp-server x dns1 0.0.0.0
Show VRRP status and statistics
This section describes how to display VRRPstatus and statistics for a TransPort device.
Web
n On the menu, click Network > Services> VRRP. The VRRP page appears.
Command line
Enter the following command:
digi.router> show vrrp