Digi TransPort LR54 - Configure a Wi-Fi Access Point with no Security

Interfaces Wi-Fi interfaces
Digi TransPort WR Routers User Guide
33
digi.router> wifi-module 1 mode access-point
digi.router> wifi-module 1 protocol ac
digi.router> wifi-module 1 band 5g
digi.router> save config
Configure a Wi-Fi access point with no security
Required configuration items
n Wi-Fi module mode
Configure the Wi-Fi module Mode as Access point.
n Wi-Fi access point(s)
Configure up to four access points on each Wi-Fi module. Access points 1-4 belong to module 1;
access points 5-9 belong to module 2. For each access point:
SSID: You can configure the SSID to use the device's serial number by including %s in the SSID.
For example, an SSID parameter value of %s-1 on a WR64 would resolve to something like
WR64-123456-1.
Security: Configure security for the access point to None.
n LAN assignment
Once you configure a Wi-Fi access point, you must assign the Wi-Fi access point to a LAN
interface. For more information, see About Local Area Networks (LANs).
Additional configuration items
See Access point options for a complete list of configuration options.
Web
1. On the menu, click Network > Interfaces > Wi-Fi.
2. Select a Wi-Fi interface to configure and set the Mode to Access point.
3. Click New Access Point to create a new access point interface on the module.
4. Configure options for the access point . See Access point options for details.
5. Click Apply.
6. Assign the new Wi-Fi access point to a WAN interface. See About Local Area Networks (LANs).
Command line
n To configure a Wi-Fi module, use the wifi-module command.
n To configure Wi-Fi access points, use the wifi-ap command.
1. Configure the Wi-Fi module for access point mode.
digi.router> wifi-module 1 mode access-point
2. Enter the SSID for the Wi-Fi access point.
digi.router> wifi-ap 1 ssid WR64-AP1