Digi TransPort LR54 - Show Hotspot Status and Statistics; Show Current Hotspot Configuration

Hotspot Show hotspot status and statistics
Digi TransPort WR Routers User Guide
135
3. Configure the Wi-Fi interface:
Note If an Ethernet interface was added to the LAN, no configuration of the Ethernet interface
is required.
a. Set the SSID for the Wi-Fi interface:
digi.router> wifi-ap 2 ssid ssid
b. Disable the Wi-Fi interface's security:
digi.router> wifi-ap 2 security none
4. Save the configuration:
digi.router> save config
Show hotspot status and statistics
View status and statistics about the hotspot at the command line using the show hotspot command:
digi.router> show hotspot
Hotspot
-------
Admin Status : Up
Operating Status : Up
LAN : lan5
Authenticated clients : 1
Unauthenticated clients : 0
MAC IP Auth? Username Duration/max sec Idle/max sec %/max up bps %/max down bps
------------------------------------------------------------------------------------------------------------
98-01-A7-8F-A5-93 10.1.0.3 Yes usertest 13/0 0/0 0%/10000000 0%/10000000
digi.router>
Show current hotspot configuration
You can view the current hotspot configuration from either the Web UI or the command line.
Web
On the menu, click Network > Services > Hotspot. The current configuration is displayed.
Command line
View the current hotspot configuration using the show hotspot command with no parameters:
digi.router> hotspot
hotspot 1:
allowed-domains
allowed-subnets
auth-mode click-through
auth-port 3990
bandwidth-max-down 10000
bandwidth-max-up 10000
dhcp-lease 600
ip-address 10.1.0.1