Digi TransPort LR54 - Location Page; Location Client Page

Web reference Location page
Digi TransPort WR Routers User Guide
312
Location page
Use the Location page to enable or disable the Global Navigation Satellite System (GNSS) module. You
can also view location details from this page when the module is enabled.
Configuration options
Option Description
State Enables location support for either the local GNSSmodule or for the location server, or
disables location support.
Server
Port
Available only if
State
is set to
Server
: Defines the IP UDP port to listen for location
messages. If set to
0
, this feature is disabled. Accepted value is any integer from
0
to
65535
. The default value is
0
.
Interval
Sets the refresh interval in seconds for reading and sending location data. Accepted value
is any integer from
1
to
3600
. The default value is
10
.
Vehicle
ID
Sets the vehicle ID to include location messages. Accepted value is any string of 4
characters.
Status display
Option Description
GNSS State The state of the GNSSmodule.
Latitude The current latitude of the TransPort device.
Longitude The current longitude of the device.
Altitude The current altitude of the device.
Horizontal Velocity The current horizontal velocity of the device.
Vertical Velocity The current vertical velocity of the device.
Direction The current direction that the device is moving.
Quality The quality of the GNSS signal.
Date Time A date and time stamp for this information.
Number of Satellites The number of satellites involved in determining the device's location.
Location Client page
Use the Location Client page to configure location clients on the TransPort device that forward
location messages in either NMEAor TAIP format to a remote host. You can configure up to ten
location clients on the device to forward location information to up to ten different remote hosts.