Digi TransPort LR54 - Openvpn-Server

Command reference openvpn-server
Digi TransPort WR Routers User Guide
401
openvpn-server
Configures an OpenVPN server.
Syntax
openvpn-server <parameter> <value>
Parameters
state
Enables or disables the OpenVPN server.
Value is either on or off. The default value is off.
description
A description of this OpenVPN server.
Accepted value is any string up to 255 characters.
network
The local network for this OpenVPN tunnel if 'bridge-mode' is set to off. This value typically ends with
'.0' to match the subnet mask.
Value should be an IPv4 address.
mask
The local subnet for this OpenVPN tunnel if 'bridge-mode' is set to off.
Value should be an IPv4 address. The default value is 255.255.255.0.
dns1
The IPv4 address of the primary DNS server. This value is pushed to OpenVPN clients if 'bridge-mode'
is set to off.
Value should be an IPv4 address.
dns2
The IPv4 address of the secondary DNS server. This value is pushed to OpenVPN clients if 'bridge-
mode' is set to off.
Value should be an IPv4 address.
port
The port this OpenVPN server uses to listen for incoming connections from OpenVPN clients.
Accepted value is any integer from 1 to 65535. The default value is 1194.
topology
The network topology this OpenVPN server uses to assign IP addresses to OpenVPN clients. This
value is only used if 'bridge-mode' is set to off.