Command reference ip-filter
Digi TransPort WR Routers User Guide
385
ip-filter
Configures IP filter rules.
Syntax
ip-filter <1 - 32> <parameter> <value>
Parameters
description
The description of this rule.
Accepted value is any string up to 255 characters.
state
Enables or disables an IP filter rule.
Value is either on or off. The default value is off.
action
Accepts, drops, or rejects IP packets.
Accepted values can be one of accept, drop or reject. The default value is accept.
src-ip-address
The IPv4 or IPv6 source address of the incoming packet. Use a simple IPv4 or IPv6 address, or use
CIDR notation (example: 192.168.100.0/24, fe80::/10)
Accepted value is any string up to 43 characters.
src-ip-port
The source port(s) of the incoming packet. Use a simple port, a range (lowport:highport) or a list
(port1,port2...,portn). Default '0' implies 'Any'. Source port is ignored when protocol does not explicitly
include tcp or udp.
Accepted value is any string up to 255 characters. The default value is 0.
dst-ip-address
The IPv4 or IPv6 destination address of the incoming packet. Use a simple IPv4 or IPv6 address, or
use CIDR notation (example: 192.168.100.0/24, fe80::/10)
Accepted value is any string up to 43 characters.
dst-ip-port
The destination port(s) of the incoming packet. Use a simple port, a range (lowport:highport) or a list
(port1,port2...,portn). Default '0' implies 'Any'. Dest port is ignored when protocol does not explicitly
include tcp or udp.
Accepted value is any string up to 255 characters. The default value is 0.
To Next Page
Loading...
