Digi TransPort LR54 - Using the Web Interface; Log in to the Web Interface; Log out of the Web Interface

Configuration and management Using the web interface
Digi TransPort WR Routers User Guide
16
Using the web interface
The first time you power on a TransPort device, the Getting Started Wizard steps you through the
process of initial configuration. After the wizard completes, the next time you access the device, a
login prompt appears. See Log in to the web interface for login instructions.
After you log in, the TransPort Dashboard appears. The Dashboard provides a snapshot of current
activity for the device. See Dashboard for details.
In this guide, task topics how how to perform tasks:
Web
Shows how to perform a task using the web interface.
Command line
Shows how to perform a task using the command line interface.
Log in to the web interface
The first time you access a TransPort device, the Getting Started Wizard runs. The wizard steps
through initial device configuration. After you run the Getting Started Wizard, the next time you access
the device, a login prompt for the web interface appears.
1. Open a browser and enter the default address for the TransPort device: http://192.168.1.1.
The Device Login prompt appears.
2. Enter your username and password, and click Login.
Note If you did not change the username or password during initial setup, use the default
username admin and the unique password printed on the device label. The device label is also
attached to the bottom of the device.
The TransPort Dashboard appears. See Dashboard.
Log out of the web interface
n Click the Logout button in the upper right corner of the web interface.