show firewall
Digi TransPort WR Routers User Guide
439
show firewall
Displays the firewall status and statistics. By default, all firewall tables are displayed. To display
individual tables, specify the table name on the show firewall command. In the command output, the
policy for each chain is also displayed in brackets after the chain name. The firewall keeps a counter
for each rule which counts the number of packets and bytes that have been matched against the rule.
This is a useful tool to determine if a rule is correctly detecting packets. To clear the counters, use the
'clear firewall' command.
Parameters
filter
The currently defined filter table for IPv4.
mangle
The currently defined mangle table for IPv4.
raw
The currently defined raw table for IPv4.
nat
The currently defined nat table for IPv4.
To Next Page
Loading...
