Digi TransPort LR54 - Openvpn-Route

Command reference openvpn-route
Digi TransPort WR Routers User Guide
400
openvpn-route
Specifies the routes the OpenVPN server pushes to OpenVPN clients so they can access resources
located behind the OpenVPN server. These resources would be otherwise unavailable since they are
on different subnets than the OpenVPN tunnel itself. Typically, these routes would only be needed for
non-bridged (TUN) configurations.
Syntax
openvpn-route <1 - 10> <parameter> <value>
Parameters
destination
Destination network for the route. This value typically ends with '.0' to match the subnet mask.
Value should be an IPv4 address.
mask
Subnet mask for the route.
Value should be an IPv4 address. The default value is 255.255.255.0.