Digi TransPort LR54 - Configure the Wi-Fi Module Channel; Configure the Wi-Fi Module Band and Protocol

Interfaces Wi-Fi interfaces
Digi TransPort WR Routers User Guide
32
Configure the Wi-Fi module channel
By default, each Wi-Fi module is configured to automatically select the best channel to use with
respect to other Wi-Fi networks. Optionally, you can configure a specific channel to use for a Wi-Fi
module using the following steps.
Note For the 2.4 GHz band, only channels 1 to 11 are supported. Channels 12, 13, and 14 are not
supported.
Web
1. On the menu, click Network > Interfaces > Wi-Fi.
2. Select a Wi-Fi module to configure, and set the Mode to Access Point.
3. In the Edit Selected box, select the channel you want to configure. Only channels appropriate
for the band are displayed.
4. Click Apply.
Command line
To configure the channel used by a Wi-Fi module, use the wifi-module.
digi.router> wifi-module 1 mode access-point
digi.router> wifi-module 1 channel 8
digi.router> save config
Configure the Wi-Fi module band and protocol
For Wi-Fi modules that support both 2.4 GHz and 5 GHz modes, you can configure the band.
n On TransPort models with only one Wi-Fi module, the default protocol and band for the one
module is the 5 GHz ac.
n On TransPort models with two Wi-Fi modules, one module defaults to use 5 GHz ac and the
other defaults to 2.4 GHz bgn band.
Web
1. On the menu, click Network > Interfaces > Wi-Fi.
2. Select the Wi-Fi module you want to configure, and set the Mode to Access Point.
3. Click Apply.
4. In the Edit Selected box, select the band for the Wi-Fi module.
5. Click Apply.
Command line
To configure the band and/or protocol used by a Wi-Fi module, use the wifi-module command.