wifi-ap
Digi TransPort WR Routers User Guide
493
wifi-ap
Configures a Wi-Fi Access Point interface.
Syntax
wifi-ap <1 - 8> <parameter> <value>
Parameters
description
A descriptive name for the Wi-Fi Access Point interface.
Accepted value is any string up to 255 characters.
ssid
Service Set Identifier (SSID) for the Wi-Fi Access Point interface. You can configure the SSID to use the
device's serial number by including '%s' in the SSID. For example, an 'ssid' parameter value of
'WR64_%s' resolves to 'WR64_WR123456.'
Accepted value is any string up to 32 characters.
security
Security for the Wi-Fi Access Point interface.
Accepted values can be one of none, wpa2-personal, wpa-wpa2-personal, wpa2-enterprise or wpa-
wpa2-enterprise. The default value is wpa2-personal.
password
Password for the Wi-Fi Access Point interface. The password must be 8-63 ASCII or 64 hexadecimal
characters
Accepted value is any string up to 132 characters.
broadcast-ssid
Enables or disables broadcasting the SSID in beacon packets. Disabling the SSID prevents clients from
easily detecting the presence of this access point.
Accepted values can be one of off or on. The default value is on.
isolate-clients
Enables or disables Wi-Fi client isolation, which prevents clients connected to the Wi-Fi access point
from communicating with each other.
Accepted values can be one of off or on. The default value is on.
isolate-ap
Enables or disables clients on a Wi-Fi access point from communicating with clients on other Access
Points.
Accepted values can be one of off or on. The default value is on.
To Next Page
Loading...
