Web reference Interfaces—Wi-Fi page
Digi TransPort WR Routers User Guide
303
Interfaces—Wi-Fi page
Use the WiFi interface page to manage Wi-Fi interfaces. Depending on the TransPort model, you can
configure one or two Wi-Fi modules.
General options
Option Description
Module 1 or Module 2
Description Description for the interface. Specify a string value up to 255 characters long.
Mode Selects the mode for the Wi-Fi module:
Access point options and Access point status and statistics
or
Client mode options and Client status and statistics
The default value is Access point.
Access point options
Option Description
Module 1 or Module 2
Band Specifies the band for the Wi-Fi module: 2.4 GHz or 5 GHz.
Channel Specifies a channel for the Wi-Fi module or auto to automatically select the best
channel for the module. Specify a channel (1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 36, 40, 44 or
48) or auto. The default value is auto.
Advanced
Protocol Specifies the protocol for the Wi-Fi module:
n For 2.4 GHz, the default and only protocol is bgn.
n For 5 GHz, select a, an, or an/ac. The default is an/ac.
TX power Specifies theTX power to use for Wi-Fi module by percentage. Specify an integer from
1 to 100. The default is 100.
For each access point
SSID Specifies the Service Set Identifier (SSID) for the Wi-Fi interface. You can configure the
SSID to use the device serial number by including the percent (%) symbol in the SSID.
For example, an SSID value WR64_%s resolves to WR64_LR123456. Enter a string up
to 32 characters long.
Description Description for the interface. Specify a string value up to 255 characters long.
To Next Page
Loading...
