Digi TransPort LR54 - Routing-Rule

routing-rule
Digi TransPort WR Routers User Guide
425
routing-rule
Configures IP filter rules.
Syntax
routing-rule <1 - 16> <parameter> <value>
Parameters
description
The description of this rule.
Accepted value is any string up to 255 characters.
state
Enables or disables a routing rule.
Value is either on or off. The default value is off.
src-ip-address
The IPv4 or IPv6 source address of the incoming packet. Use a simple IPv4 or IPv6 address, or use
CIDR notation (example: 192.168.100.0/24, fe80::/10)
Accepted value is any string up to 43 characters.
src-ip-port
The source port(s) of the incoming packet. Use a simple port, a range (lowport:highport) or a list
(port1,port2...,portn). Default '0' implies 'Any'. Source port is ignored when protocol does not explicitly
include tcp or udp.
Accepted value is any string up to 255 characters. The default value is 0.
dst-ip-address
The IPv4 or IPv6 destination address of the incoming packet. Use a simple IPv4 or IPv6 address, or
use CIDR notation (example: 192.168.100.0/24, fe80::/10)
Accepted value is any string up to 43 characters.
dst-ip-port
The destination port(s) of the incoming packet. Use a simple port, a range (lowport:highport) or a list
(port1,port2...,portn). Default '0' implies 'Any'. Dest port is ignored when protocol does not explicitly
include tcp or udp.
Accepted value is any string up to 255 characters. The default value is 0.
src
The source interface of the incoming traffic.
Accepted values can be one of any, any-lan, lan1, lan2, lan3, lan4, lan5, lan6, lan7, lan8, lan9, lan10 or
hotspot. The default value is any.