System settings Configure Power button power down behavior
Digi TransPort WR Routers User Guide
239
To display the current system date and time, use the date command.
digi.router> date
system time: 14:55:06, 03 May 2016
digi.router>
Configure Power button power down behavior
The Digi router's front panel includes a Power button.
n If the device is off, press the Power button to turn on the device.
n If the device is on, the Power button includes short-press and long-press options. By default,
both short-press and long-press Power button actions power down the device.
You can configure how the Power button powers down the device using the power command. For
example, to prevent accidentally powering down the device when the Power button is accidentally
pressed, you can disable the Power button short-press power down. Or, you can completely disable
the Power button for power down—both short- and long-presses.
To prevent short-press Power button power down:
digi.router> power button disable-power-down
digi.router> save config
To completely prevent power down using the Power button:
digi.router> power button disable-all-power-down
digi.router> save config
Pressing the Power button when the device is off always powers on the device, regardless of how you
configure Power button power down options.
Configure power delays for power ignition sensor
The Digi TransPort device automatically powers on and powers off when it detects power on the
ignition sensor. By default, there is no delay for either power on or power off based on the power
ignition sensor.
You can configure delays for powering on or off the system using the power command.
To set a delay time of five minutes (300 seconds) for power off when the ignition power sensor goes
off:
digi.router> power ignition-off-delay 60
digi.router> save config
To set a delay time of two minutes (120 seconds) for power on when the ignition power sensor goes
on:
digi.router> power ignition-on-delay 120
digi.router> save config
Note If the Digi TransPort device does not automatically power on within the configured ignition-on
delay time, you can manually power on the device using the Power button.
To Next Page
Loading...
