Digi TransPort LR54 - Using the Command Line; Access the Command Line Interface; Log in to the Command Line Interface; Exit the Command Line Interface

Configuration and management Using the command line
Digi TransPort WR Routers User Guide
17
Using the command line
Digi TransPort provides a command-line interface you can use to configure the device, display status
and statistics, as well as update firmware and manage device files. See Command reference for
details on all available commands.
In this guide, task topics how how to perform tasks:
Web
Shows how to perform a task using the web interface.
Command line
Shows how to perform a task using the command line interface.
Access the command line interface
You can access the TransPort device using the serial1 interface or SSH connection. You can use open-
source terminal software, such as PuTTY and TeraTerm.
Alternatively, you can open the command line interface in the web interface via the Device Console:
n On the menu, click System > Device Console. The Device Console appears.
Log in to the command line interface
1. Connect to the TransPort device via the Serial 1 interface or with a SSH connection.
n For Serial connections, the baud rate is 115200, 8 data bits, no parity, 1 stop bit, and no
flow control.
n For SSH connections, the default IP address of the device is 192.168.1.1.
2. At the login prompt, enter the username and password. The default username is admin. The
unique password for your device is printed on the device label.
Username: admin
Password: **********
A welcome message appears, followed by the current access permission level for your username and
the timeout for the command session, followed by the systemcommand prompt.
Welcome admin
Access Level: super
Timeout : 3600 seconds
digi.router>
Exit the command line interface
Enter the exit command.