Web reference OpenVPN client page
Digi TransPort WR Routers User Guide
321
OpenVPN client page
Use the OpenVPN client page to set up OpenVPN clients.
Connection options
Option Description
Enable Enables or disables the OpenVPN client connection. The default is disabled.
Description Description for the OpenVPN client. Specify a string value up to 255 characters long.
Port Port number to which this OpenVPN client attempts to connect. Enter an integer
from 1 to 65535. The default is 1194.
Protocol Protocol that this OpenVPN client uses to connect: UDP or TCP. The default is UDP.
Compression Compression algorithm this OpenVPN client uses to compress data channel packets:
Off, lzo, lz4, or any. Setting the value to any allows the client to accept the value
provided by the server. The default is Off.
Logging
Level
Specifies the level of output this OpenVPN client records in the system log. Specify
an integer from 0 to 4. The default is 0.
Network options
Option Description
Server IP address or fully-qualified domain name of the OpenVPN server to which this OpenVPN
client attempts to connect. This option is required.
Pull
Routes
Enables or disables the OpenVPN client to accept routes that are pushed from the
OpenVPN server. The default is enabled.
NAT Enables or disables Network Address Translation (NAT) for outgoing packets on the
OpenVPN client network interface. Note that the OpenVPN client uses NAT only if the
Bridge mode is disabled. The default is enabled.
Bridge
Mode
Specify a LAN as an Ethernet bridge (TAP) for this OpenVPN client or disable Bridge mode.
Note Although using Bridge mode eliminates the need for routing between networks
(required by TUN mode), Bridge mode can cause scalability issues since all broadcast
traffic flows over the OpenVPN tunnel.
The default is Off.
To Next Page
Loading...
