Digi TransPort LR54 - System Settings; Configure System Settings

System settings Configure system settings
Digi TransPort WR Routers User Guide
231
Configure system settings
The TransPort device has several system settings that control the general behavior of the device and
information displayed about the device.
Web
On the menu, click System > Administration. System options include the following:
n Remote Manager: Configures the connection to Digi Remote Manager. See Remote Manager.
n File System: Displays the local file system for the TransPort device and allows you to perform
file management operations. See File system.
n Device Console: Opens the Device Console, from which you can execute commands. See
Execute a command from the web interface.
n Logs: Displays the event and system logs. See Logs.
n Firmware Update: Updates operating system firmware and other device firmware. See
Update system firmware.
n Reboot: Reboots the device. See Reboot the device.
Command line
Use the system command to configure the following system options:
n System prompt for CLI: The default system prompt is digi.router>. You can configure the
system prompt to be any value of up to 16 characters. To use the device's serial number in the
system prompt, include %s in the prompt parameter value. For example, a prompt parameter
value of LR54_%s resolves to LR54_LR123456.
n CLI timeout: This is the time, in seconds, after which the command-line interface times out if
there is no activity. The default is 180 seconds. You can specify any value between 60 and 3600
seconds.
n Minimum event level to log: The minimum event level that is logged in the event log. The
default value is info, but you can also set the event level to the following levels: emergency,
alert, critical, error, warning, notice, or debug. For more information on the event log, see
Logs, Event log levels, and Configure options for event and system logs.
n Name: The name of this device.
n Location: The location of this device.
n Contact: Contact information for this device.
n Default page size: The page size for command-line interface output; that is, the number of
lines of output displayed. The default value is 40. You can set the page size to any value
between 0 and 100.
n Device-specific passwords: Encrypted passwords can be device-specific or not. When
encrypted passwords are device-specific, they are more secure, but cannot be copied onto
another device. By default, device-specific passwords are disabled, but you can enable them if
required.
n Description: A description of this device.