Digi TransPort LR54 - System

system
Digi TransPort WR Routers User Guide
480
system
Configures system settings.
Syntax
system <parameter> <value>
Parameters
prompt
The prompt displayed in the command-line interface. You can configure the system prompt to use the
device's serial number by including '%s' in prompt value. For example, a 'prompt' parameter value of
'WR64_%s' resolves to 'WR64_WR123456.'
Accepted value is any string up to 16 characters. The default value is digi.router>.
timeout
The time, in seconds, after which a web or command-line interface session times out if there is no
activity.
Accepted value is any integer from 60 to 3600. The default value is 300.
loglevel
The minimum event level that is logged in the event log.
Accepted values can be one of emergency, alert, critical, error, warning, notice, info or debug. The
default value is info.
name
The name of this device.
Accepted value is any string up to 255 characters.
location
The location of this device.
Accepted value is any string up to 255 characters.
contact
Contact information for this device.
Accepted value is any string up to 255 characters.
page
Sets the page size for command-line interface output.
Accepted value is any integer from 0 to 100. The default value is 40.
device-specific-passwords
Enables or disables device-specific passwords. Encrypted passwords can be device-specific or not.
When encrypted passwords are device-specific, they are more secure, but cannot be copied onto