Digi TransPort LR54 - Show Ethernet Status and Statistics

Interfaces Ethernet interfaces
Digi TransPort WR Routers User Guide
23
Command line
1. Enable the Ethernet interface. By default, all of the Ethernet interfaces are enabled.
digi.router> eth 1 state on
2. Optional: Set the description for the Ethernet interface. For example:
digi.router> eth 1 description “Connected to Ethernet WAN router”
3. Optional: Set the duplex mode.
digi.router> eth 1 duplex {auto | full | half}
4. Optional: Set the speed.
digi.router> eth 1 speed {auto | 1000 | 100 | 10}
5. Save the configuration.
digi.router> save config
Show Ethernet status and statistics
You can view the status and statistics of Ethernet interfaces from either the Dashboard of the web
interface, or from the command line:
Web
1. On the menu, click Dashboard.
The Interface section of the dashboard shows the status of all interfaces.
2. Click on an interface, or click Network > Interfaces > Ethernet to view detailed status and
statistics for each interface.
Command line
To show the status and statistics for the Ethernet interface, use the show eth command. For example:
digi.router> show eth
Eth Status and Statistics Port 1
-------------------------------------
Description : Factory default configuration for Ethernet 1
Admin Status : Up
Oper Status : Up
Up Time : 1 Day, 13 Hours, 30 Minutes, 23 Seconds
MAC Address : 00:50:18:21:E2:82
DHCP : off
IP Address : 10.52.19.242
Netmask : 255.255.255.0
DNS Server(s) :